Differences

This shows you the differences between two versions of the page.

--- engage_space:power [2018/05/13 14:07] – Inital Design dococassi
+++ engage_space:power [2018/05/25 07:50] – /* Distribution */ dococassi
@@ Line 14: / Line 14: @@
   *  32 Amp Ring (P3)
-The cables run to the first floor and should be tapable there to continue to a Consumer unit int the dirty workshop
+The cables run to the first floor and should be tapable there to continue to a Consumer unit in the dirty workshop, the 16 could be changed for a 32. though this would require replacement of the cable.
-I have a draft distribution, we will need to prioritize what parts to tackle first.
+Potentially we could change the breaker upstairs to 40A and use a 32A breaker in our box which would remove the risk of tripping the breaker upstairs by distributed load.
-{{file_electrical-01.pngDraft Electrical Termination Diagram}}
-====== Circuit Breaker Box ======
+====== Consumer Unit ======
-Our breakers are located in a box.
-Peter generously donated a consumer unit for us. The best place for it would be in the dirty workshop on the right as you come in the door.
+We have a schnider Easy9 Distribution box in the hall next to the dirty workshop
-See the drawing above to identify required breakers in the box, there can be expansion
-TODO:
+====== Distribution ======
-  *  Identify and source breakers.
+This will be done by 50mmx50mm Conduit you can see the plan for distribution below, Iain did some good work mounting the first section of trunking and Consumer unit, you can also see the board for work to be done.
-====== Ring Main ======
-See drawing above for rings. O think we can get away with three one for each area.
+  {{file_floorplan-conduit.png?400x0}}{{file_m2-3.jpg?400x0}}
-TODO:
-  *  How to run cables between floors.
-  *  Outlets locations
-  *  Conduit size and location