projects:other_3d_printers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | |||
projects:other_3d_printers [2022/09/07 13:23] – hibby | projects:other_3d_printers [2023/04/23 12:14] (current) – Stephanie Davidson | ||
---|---|---|---|
Line 43: | Line 43: | ||
After-print care washing is needed for prints from this printer. This consists of a bath of either IPA or similar solvent. A washing tank is recommended to address COSHH concerns. | After-print care washing is needed for prints from this printer. This consists of a bath of either IPA or similar solvent. A washing tank is recommended to address COSHH concerns. | ||
- | ===== Maker Architect " | ||
- | {{: | ||
- | **Manufacturer: | ||
- | **Source:** Donated to the space, 17/ | ||
- | **Location: | ||
- | **Summary: | ||
- | **State:** Machine powers on, reports temps and demonstrates working endstops on auto-homing. The printer has slightly jerky rod movement and is pretty dirty/dusty from use and storage. Semi-auto bed-levelling test's ok, heaters reach temps with no problems. Prints can be started via USB or via SD card. | ||
- | |||
- | In order to be able to print, the following maintenance steps will be required first: | ||
- | * Rods in need of greasing | ||
- | * surfaces require cleaning | ||
- | * Reel dispensing solution required | ||
- | |||
- | UPDATE 20/01/21: The manual has been located and can be downloaded {{ : | ||
- | ===== Ultimaker Original+ " | ||
{{: | {{: | ||
**Manufacturer: | **Manufacturer: |
projects/other_3d_printers.txt · Last modified: 2023/04/23 12:14 by Stephanie Davidson