Difference between revisions of "Projects:HackyLEDS"

From 57North Hacklab

(Notes)
(Notes)
(4 intermediate revisions by the same user not shown)
Line 5: Line 5:
 
}}
 
}}
 
== Location ==
 
== Location ==
* ScotCon room, installed on to the ceiling
+
* 2x installed and in use in the ceiling; one flood and one strip light.
 +
* 2x stored unused under the left-side desk in the social room; one flood and one strip light.
  
 
== Safety Hazards ==
 
== Safety Hazards ==
* There is a 240 volt feed to a wall-mounted 12v supply. The cover should always be down over the cover and ideally a 'Danger Mains Voltage' sticker added to it (on order)
+
* The LEDs should be used only in ventilated areas that allow heat to dissipate.
  
 
== Notes ==
 
== Notes ==
* Controlled via MQTT on a ESP8266 running Micropython ([https://github.com/Nordln/HackyLEDS View on Github])
+
* Powered via 12v, ran over an ESP8266 plugged into variboard soldered with FETS, hosted inside a white 'blokbox'.
 +
* Controlled using MQTT over Wifi on a ESP8266 running Micropython and custom code ([https://github.com/Nordln/HackyLEDS View on Github])
 
[[Category:Large Items]]
 
[[Category:Large Items]]

Revision as of 14:36, 13 March 2019

HackyLEDS
Description Home-made LED Lights installed on the upper floor
People User:Nordin
Theme
Website
Status Active

Location

  • 2x installed and in use in the ceiling; one flood and one strip light.
  • 2x stored unused under the left-side desk in the social room; one flood and one strip light.

Safety Hazards

  • The LEDs should be used only in ventilated areas that allow heat to dissipate.

Notes

  • Powered via 12v, ran over an ESP8266 plugged into variboard soldered with FETS, hosted inside a white 'blokbox'.
  • Controlled using MQTT over Wifi on a ESP8266 running Micropython and custom code (View on Github)