projects:laser_cutter
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projects:laser_cutter [2020/10/11 23:38] – Midder | projects:laser_cutter [2022/11/22 17:58] – [Notes] andy | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Laser Cutter ====== | ====== Laser Cutter ====== | ||
===== Location ===== | ===== Location ===== | ||
- | * Next to wigh tool workbench beside window, at front | + | * Next to the 3D Printers |
- | ====== Hazards | + | ===== Hazards === |
* '' | * '' | ||
* '' | * '' | ||
* '' | * '' | ||
- | == Notes == | ||
- | * The hardware is a KH-3020 'Laser Engraving Machine' | ||
- | * Dimensions: Width 810mm x depth 510mm x height 260mm (at highest) | ||
- | * The note ' | ||
- | * It is currently water-cooled via water piped though an ice bath. | ||
- | * The cut size is approx A4. | ||
- | * Ventilation is achieved via a fan and a length of approx 3m of large tubing that exits the machine rear | ||
- | * A new cooling solution is in development, | ||
- | ===== Current | + | ===== Current |
- | 1. Set up again next to window | + | In place |
- | 2. Cleaned the bed mirrors and Lens, all not in good condition, (rear mirror still to check.) | + | |
===== TODO ===== | ===== TODO ===== | ||
- | * Set up Cooling. | + | |
- | * Air filter,and exhaust outside through window when in use. | + | |
- | * computer and software to operate. | + | |
- | * Check the bed for focal length of laser | + | |
- | *Possible* | ||
- | * Better temp control for cooler | ||
- | * Air Assist for the cut, requires air pump. | ||
- | * switch to shut off when door open, or lock. | ||
- | * EMS? | ||
- | ====Current State==== | ||
- | In place but needs above to be completed before operation. | + | ===== Notes ===== |
+ | * The hardware is a Trotec Speedy100 | ||
+ | * The manual [[https:// | ||
- | ===== Software | + | The focus guide sits on the lase cutter like so... |
- | We have successfully driven | + | {{: |
+ | ==== Software ==== | ||
+ | The software to drive the cutter is on the associated laptop. | ||
- | {{tag>project active | + | {{tag> |
projects/laser_cutter.txt · Last modified: 2022/12/03 18:03 by andy