projects:laser_cutter
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projects:laser_cutter [2020/10/12 07:36] – Midder | projects:laser_cutter [2022/12/03 11:15] – andy | ||
---|---|---|---|
Line 1: | Line 1: | ||
====== Laser Cutter ====== | ====== Laser Cutter ====== | ||
===== Location ===== | ===== Location ===== | ||
- | * Next to the high workbench beside window, at front | + | * Next to the 3D Printers |
===== Hazards === | ===== Hazards === | ||
Line 11: | Line 11: | ||
===== Current State ===== | ===== Current State ===== | ||
- | In place but needs above to be completed before operation. | + | In place |
- | + | ||
- | ===== Current progress ===== | + | |
- | + | ||
- | - Set up again next to window | + | |
- | - Cleaned the bed mirrors and Lens, all not in good condition, (rear mirror still to check.) | + | |
===== TODO ===== | ===== TODO ===== | ||
- | * Set up Cooling. | + | * Fix laser issue - [[https:// |
- | * Air filter,and exhaust outside through window when in use. | + | |
- | * computer and software to operate. | + | |
- | * Check the bed for focal length of laser | + | |
- | **Possible** | ||
- | * Better temp control for cooler | ||
- | * Air Assist for the cut, requires air pump. | ||
- | * switch to shut off when door open, or lock. | ||
- | * EMS? | ||
===== Notes ===== | ===== Notes ===== | ||
- | * The hardware is a KH-3020 'Laser Engraving Machine' | + | * The hardware is a Trotec Speedy100 |
- | * Dimensions: Width 810mm x depth 510mm x height 260mm (at highest) | + | * The maximum size of a sheet to cut is 610 x 305 mm |
- | * The note 'Vinyl: 80mm/s 50%' is written on the machine' | + | * The manual [[https:// |
- | * It is currently water-cooled via water piped though an ice bath. | + | |
- | | + | The focus guide sits on the laser cutter like so... |
- | * Ventilation is achieved via a fan and a length of approx 3m of large tubing that exits the machine rear | + | {{: |
- | * A new cooling solution is in development, | + | |
==== Software ==== | ==== Software ==== | ||
- | We have successfully driven | + | The software to drive the cutter is on the associated laptop. |
+ | |||
+ | ==== Links ==== | ||
+ | |||
+ | * Some useful notes [[https:// | ||
+ | * Trotec samples and examples | ||
+ | |||
+ | |||
+ | ===== Photos ===== | ||
+ | |||
+ | {{: | ||
- | {{tag>project active | + | {{tag> |
projects/laser_cutter.txt · Last modified: 2022/12/03 18:03 by andy