projects:other_3d_printers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projects:other_3d_printers [2021/01/21 10:09] – [Reprap Prusa Mendel "Arthur"] Ed | projects:other_3d_printers [2021/01/22 10:05] – [Kossel Mini "Webster"] Ed | ||
---|---|---|---|
Line 46: | Line 46: | ||
{{: | {{: | ||
**Manufacturer: | **Manufacturer: | ||
- | **Source:** Donated to the space, 17/ | + | **Source:** Donated to the space, 17/ |
+ | **Location: | ||
**Summary: | **Summary: | ||
Line 80: | Line 81: | ||
**Summary: | **Summary: | ||
- | **State:** The machine powers on and prints via wifi using the onboard OctoPi installation. The print area is small due to bed-leveling limitations (printable area drawn on bed itself). Manual 3-point bed-levelling is done using the GUI to position. Fast or fine detail prints are not recommended. The power supply has been repurposed and may need to be replaced. | + | **State:** The machine powers on and prints via wifi using the onboard OctoPi installation. The print area is small due to bed-leveling limitations (printable area drawn on bed itself). Manual 3-point bed-levelling is done using the GUI to position. Fast or fine detail prints are not recommended. The 12v 20A power supply has been repurposed and may need to be replaced. |
In order to be able to print, the following maintenance steps will be required first: | In order to be able to print, the following maintenance steps will be required first: | ||
- | * Bed re-levelling | + | * Manual bed re-levelling |
* Source a power supply | * Source a power supply | ||
Line 91: | Line 92: | ||
**Manufacturer: | **Manufacturer: | ||
**Source:** [https:// | **Source:** [https:// | ||
- | **Location: | + | **Location: |
**Summary: | **Summary: | ||
projects/other_3d_printers.txt · Last modified: 2023/04/23 12:14 by Stephanie Davidson