projects:other_3d_printers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projects:other_3d_printers [2021/01/22 10:04] – [Reprap Prusa Mendel "Arthur"] Ed | projects:other_3d_printers [2021/01/22 10:08] – [Kossel Mini "Webster"] Ed | ||
---|---|---|---|
Line 47: | Line 47: | ||
**Manufacturer: | **Manufacturer: | ||
**Source:** Donated to the space, 17/ | **Source:** Donated to the space, 17/ | ||
- | **Location: | + | **Location: |
**Summary: | **Summary: | ||
Line 81: | Line 81: | ||
**Summary: | **Summary: | ||
- | **State:** The machine powers on and prints via wifi using the onboard OctoPi installation. The print area is small due to bed-leveling limitations (printable area drawn on bed itself). Manual 3-point bed-levelling is done using the GUI to position. Fast or fine detail prints are not recommended. The power supply has been repurposed and may need to be replaced. | + | **State:** The machine powers on and prints via wifi using the onboard OctoPi installation. The print area is small due to bed-leveling limitations (printable area drawn on bed itself). Manual 3-point bed-levelling is done using the GUI to position. Fast or fine detail prints are not recommended. The 12v 30A power supply has been repurposed and may need to be replaced. |
In order to be able to print, the following maintenance steps will be required first: | In order to be able to print, the following maintenance steps will be required first: | ||
Line 87: | Line 87: | ||
* Source a power supply | * Source a power supply | ||
+ | UPDATE 22/01/21: Alternative power supply located. Drop-off at space pending. | ||
===== Reprap Prusa Mendel " | ===== Reprap Prusa Mendel " | ||
{{: | {{: |
projects/other_3d_printers.txt · Last modified: 2023/04/23 12:14 by Stephanie Davidson