projects:other_3d_printers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionNext revisionBoth sides next revision | ||
projects:other_3d_printers [2021/01/22 10:05] – [Kossel Mini "Webster"] Ed | projects:other_3d_printers [2021/02/02 20:28] – [Maker Architect "Woods"] Wouter | ||
---|---|---|---|
Line 48: | Line 48: | ||
**Source:** Donated to the space, 17/ | **Source:** Donated to the space, 17/ | ||
**Location: | **Location: | ||
- | **Summary: | + | **Summary: |
**State:** Machine powers on, reports temps and demonstrates working endstops on auto-homing. The printer has slightly jerky rod movement and is pretty dirty/dusty from use and storage. Semi-auto bed-levelling test's ok, heaters reach temps with no problems. Prints can be started via USB or via SD card. | **State:** Machine powers on, reports temps and demonstrates working endstops on auto-homing. The printer has slightly jerky rod movement and is pretty dirty/dusty from use and storage. Semi-auto bed-levelling test's ok, heaters reach temps with no problems. Prints can be started via USB or via SD card. | ||
Line 79: | Line 79: | ||
**Source:** Ebay, kit purchased 05/ | **Source:** Ebay, kit purchased 05/ | ||
**Location: | **Location: | ||
- | **Summary: | + | **Summary: |
- | **State:** The machine powers on and prints via wifi using the onboard OctoPi installation. The print area is small due to bed-leveling limitations (printable area drawn on bed itself). Manual 3-point bed-levelling is done using the GUI to position. Fast or fine detail prints are not recommended. The 12v 20A power supply has been repurposed and may need to be replaced. | + | **State:** The machine powers on and prints via wifi using the onboard OctoPi installation. The print area is small due to bed-leveling limitations (printable area drawn on bed itself). Manual 3-point bed-levelling is done using the GUI to position. Fast or fine detail prints are not recommended. The 12v 30A power supply has been repurposed and may need to be replaced. |
In order to be able to print, the following maintenance steps will be required first: | In order to be able to print, the following maintenance steps will be required first: | ||
+ | * Investigate/ | ||
* Manual bed re-levelling (upgrading to BLtouch-driven autoleveling would be a vast improvement) | * Manual bed re-levelling (upgrading to BLtouch-driven autoleveling would be a vast improvement) | ||
* Source a power supply | * Source a power supply | ||
+ | UPDATE 22/01/21: Alternative power supply located. Drop-off at space pending. | ||
===== Reprap Prusa Mendel " | ===== Reprap Prusa Mendel " | ||
{{: | {{: |
projects/other_3d_printers.txt · Last modified: 2023/04/23 12:14 by Stephanie Davidson