resources:electronics:attiny85
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revision | Next revisionBoth sides next revision | ||
attiny85 [2017/09/09 01:01] – irl | resources:electronics:attiny85 [2020/04/21 21:33] – ↷ Page moved from attiny85 to resources:electronics:attiny85 hibby | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | {{file_irl-attiny-neopixel.jpg? | + | {{file:irl-attiny-neopixel.jpg? |
The [[attiny]] series are a very cheap series of [[microcontroller]] that can be used to create more permanent circuits without having to sacrifice your [[arduino_uno]]. | The [[attiny]] series are a very cheap series of [[microcontroller]] that can be used to create more permanent circuits without having to sacrifice your [[arduino_uno]]. | ||
Line 9: | Line 9: | ||
When using an ATtiny85 with the Arduino IDE, the pinout looks like this: | When using an ATtiny85 with the Arduino IDE, the pinout looks like this: | ||
- | {{file_attiny85-arduino-pinout.jpg}} | + | {{file: |
Line 17: | Line 17: | ||
Connect up the Uno to the ATtiny85 on a [[breadboard]] like so: | Connect up the Uno to the ATtiny85 on a [[breadboard]] like so: | ||
- | {{file_attiny85-uno-isp.jpg}} | + | {{file: |
When selecting the board in the Arduino IDE, **never** select an external oscillator setting unless you actually have one, you can brick your chip. By default, the ATtiny85 will work at 1 MHz. You can change the fuse settings in the chip to the settings you selected by choosing "Burn Bootloader" | When selecting the board in the Arduino IDE, **never** select an external oscillator setting unless you actually have one, you can brick your chip. By default, the ATtiny85 will work at 1 MHz. You can change the fuse settings in the chip to the settings you selected by choosing "Burn Bootloader" |
resources/electronics/attiny85.txt · Last modified: 2020/07/07 20:48 by 127.0.0.1