Differences

This shows you the differences between two versions of the page.

--- projects:other_3d_printers [2021/09/07 20:09] – hibby
+++ projects:other_3d_printers [2023/04/23 12:14] (current) – Stephanie Davidson
@@ Line 43: / Line 43: @@
 After-print care washing is needed for prints from this printer. This consists of a bath of either IPA or similar solvent. A washing tank is recommended to address COSHH concerns.
-===== Maker Architect "Woods" =====
-{{:projects:replicator-2.jpg?400|Replicator 2 "Woods"}}\\
-**Manufacturer:** Monoprice (The model is a 'FlashForge Creator' clone dated approx 2018, running Makerbot Replicator 2 firmware).\\
-**Source:** Donated to the space, 17/01/2021.\\
-**Location:** On-loan to space member and is held at their home address.\\
-**Summary:** Dual-extruder FDM printer, 2x 1.75mm filament; semi-auto bed-leveling; needs cleaning and lubricating; working, pending light maintenance.
-**State:** Machine powers on, reports temps and demonstrates working endstops on auto-homing. The printer has slightly jerky rod movement and is pretty dirty/dusty from use and storage. Semi-auto bed-levelling test's ok, heaters reach temps with no problems. Prints can be started via USB or via SD card.
-In order to be able to print, the following maintenance steps will be required first:
-  * Rods in need of greasing
-  * surfaces require cleaning
-  * Reel dispensing solution required
-UPDATE 20/01/21: The manual has been located and can be downloaded {{ :projects:maker_architect_13861.pdf |here}}
-===== Ultimaker Original+ "Planck" =====
 {{:projects:ultimaker.jpg?400|Ultimaker "Plank"}}\\
 **Manufacturer:** Ultimaker\\
@@ Line 112: / Line 97: @@
 It would be good for someone to itemise these at some point.
-{{tag>project active tools}}
+{{tag>tools}}