57North Hacklab

User Tools

Site Tools

You are here: start » projects » 3d_printer
projects:3d_printer

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Next revisionBoth sides next revision
projects:3d_printer [2020/04/18 23:02] – Edprojects:3d_printer [2020/07/07 21:35] – hibby
Line 4: Line 4:
  
  
-{{ file:432px-lulzbot-mini.jpg?|LulzNot Mini, Source: lulzbot.com}}+{{file:432px-lulzbot-mini.jpg?|left| LulzBot Mini, Source: lulzbot.com}} 
  
 The lulzbot has been setup next to the Kossel 3D printer and connected to power and a Dell laptop.  There are printed instructions located to the side of the printer and new users are recommended to read these before using the printer. These are also available online. The lulzbot has been setup next to the Kossel 3D printer and connected to power and a Dell laptop.  There are printed instructions located to the side of the printer and new users are recommended to read these before using the printer. These are also available online.
Line 42: Line 43:
  
 ===== Replacing the 3D Filament ===== ===== Replacing the 3D Filament =====
-[[File:Lulzbot_head.jpeg|550px|right|]]+{{File:Lulzbot_head.jpeg|550px|left|}}
 Full instructions are provided in the quick start guide, however the steps can be summised via the following: Full instructions are provided in the quick start guide, however the steps can be summised via the following:
  
projects/3d_printer.txt · Last modified: 2022/09/07 20:26 by hibby