Differences

This shows you the differences between two versions of the page.

--- projects:laser_cutter [2020/07/07 20:48] – external edit 127.0.0.1
+++ projects:laser_cutter [2020/10/11 23:36] – [Current progress] Midder
@@ Line 1: / Line 1: @@
 ====== Laser Cutter ======
 ===== Location =====
-  * On top of a built-in desk, under the middle window, in the upper floor room.
+  * Next to wigh tool workbench beside window, at front
 ====== Hazards ====
@@ Line 18: / Line 18: @@
 ===== Current progress =====
-It was proposed that the cutter is moved to under the left-side window, near to entrance to the floor toilet since entilation and cooling is a better fit here
-<gallery>
+. Set up again next to window
-File:Cutter proprosed.jpg|Wireframe shown includes rear fanblock
+. Cleaned the bed mirrors and Lens, all not in good condition, (rear mirror still to check.)
-File:Laser cutter installed.jpg|Test-fitted on wooded shelving
-File:Laser cutter rear.jpg|Position of vents relative to window (that now opens unimpeded)
-</gallery>
+===== TODO =====
+* Set up Cooling.
+* Air filter,and exhaust outside through window when in use.
+* computer and software to operate.
+* Check the bed for focal length of laser
+*Possible*
+* Better temp control for cooler
+* Air Assist for the cut, requires air pump.
+* switch to shut off when door open, or lock.
+* EMS?
 ====Current State====
 The cutter is currently inoperative but has been moved to the window location where a shelf has been installed. Nordin is currently measuring up a panel that will house the external-facing fans/vents under the window pane and will email progress to the maillist.
@@ Line 32: / Line 41: @@
 We have successfully driven the laser with [[https://www.scorchworks.com/K40whisperer/k40whisperer.html]].
-{{tag>projects active resources tools infrastructure electronics todo media}}
+{{tag>projects active resources tools infrastructure electronics}}