Differences

This shows you the differences between two versions of the page.

--- projects:laser_cutter [2020/10/11 23:31] – [Location] Midder
+++ projects:laser_cutter [2020/10/11 23:36] – [Current progress] Midder
@@ Line 18: / Line 18: @@
 ===== Current progress =====
-It was proposed that the cutter is moved to under the left-side window, near to entrance to the floor toilet since entilation and cooling is a better fit here
-{{File:Cutter proprosed.jpg|Wireframe shown includes rear fanblock}}
+. Set up again next to window
-{{File:Laser cutter installed.jpg|Test-fitted on wooded shelving}}
+. Cleaned the bed mirrors and Lens, all not in good condition, (rear mirror still to check.)
-{{File:Laser cutter rear.jpg|Position of vents relative to window (that now opens unimpeded)}}
+===== TODO =====
+* Set up Cooling.
+* Air filter,and exhaust outside through window when in use.
+* computer and software to operate.
+* Check the bed for focal length of laser
+*Possible*
+* Better temp control for cooler
+* Air Assist for the cut, requires air pump.
+* switch to shut off when door open, or lock.
+* EMS?
 ====Current State====
 The cutter is currently inoperative but has been moved to the window location where a shelf has been installed. Nordin is currently measuring up a panel that will house the external-facing fans/vents under the window pane and will email progress to the maillist.