projects:laser_cutter
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
projects:laser_cutter [2022/11/22 17:58] – [Notes] andy | projects:laser_cutter [2022/12/03 18:03] (current) – andy | ||
---|---|---|---|
Line 15: | Line 15: | ||
===== TODO ===== | ===== TODO ===== | ||
- | * Set laptop with print spool driver. | + | * Fix laser issue - [[https:// |
Line 21: | Line 21: | ||
===== Notes ===== | ===== Notes ===== | ||
* The hardware is a Trotec Speedy100 | * The hardware is a Trotec Speedy100 | ||
+ | * The maximum size of a sheet to cut is 610 x 305 mm | ||
+ | * Typically create designs in [[https:// | ||
+ | * In your design, use hairline red for cutting and black for engraving | ||
* The manual [[https:// | * The manual [[https:// | ||
+ | * Service manual {{ : | ||
+ | * The laser cutter is powered by a [[https:// | ||
- | The focus guide sits on the lase cutter like so... | + | |
+ | The focus guide sits on the laser cutter like so... | ||
{{: | {{: | ||
+ | |||
+ | |||
==== Software ==== | ==== Software ==== | ||
The software to drive the cutter is on the associated laptop. | The software to drive the cutter is on the associated laptop. | ||
+ | |||
+ | ==== Links ==== | ||
+ | |||
+ | * Some useful notes [[https:// | ||
+ | * Trotec samples and examples [[https:// | ||
+ | * | ||
+ | |||
+ | |||
+ | ===== Photos ===== | ||
+ | |||
+ | {{: | ||
+ | |||
{{tag> | {{tag> | ||
projects/laser_cutter.1669139919.txt.gz · Last modified: 2022/11/22 17:58 by andy