projects:other_3d_printers
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
projects:other_3d_printers [2021/01/22 10:16] – [Kossel Mini "Webster"] Ed | projects:other_3d_printers [2023/04/23 12:14] (current) – Stephanie Davidson | ||
---|---|---|---|
Line 43: | Line 43: | ||
After-print care washing is needed for prints from this printer. This consists of a bath of either IPA or similar solvent. A washing tank is recommended to address COSHH concerns. | After-print care washing is needed for prints from this printer. This consists of a bath of either IPA or similar solvent. A washing tank is recommended to address COSHH concerns. | ||
- | ===== Maker Architect " | ||
- | {{: | ||
- | **Manufacturer: | ||
- | **Source:** Donated to the space, 17/ | ||
- | **Location: | ||
- | **Summary: | ||
- | **State:** Machine powers on, reports temps and demonstrates working endstops on auto-homing. The printer has slightly jerky rod movement and is pretty dirty/dusty from use and storage. Semi-auto bed-levelling test's ok, heaters reach temps with no problems. Prints can be started via USB or via SD card. | ||
- | |||
- | In order to be able to print, the following maintenance steps will be required first: | ||
- | * Rods in need of greasing | ||
- | * surfaces require cleaning | ||
- | * Reel dispensing solution required | ||
- | |||
- | UPDATE 20/01/21: The manual has been located and can be downloaded {{ : | ||
- | ===== Ultimaker Original+ " | ||
{{: | {{: | ||
**Manufacturer: | **Manufacturer: | ||
Line 96: | Line 81: | ||
**Summary: | **Summary: | ||
- | **State:** Unused for some time and in need of a hot-head rebuild. Previously, the main board (Sanguinoliu 1.3a) failed due to over-heating problems at the PID hot-bed power output. The board' | + | **State:** Unused for some time. Head has been recently rebuilt using reprinted carriage |
In order to be able to print, the following maintenance steps will be required first: | In order to be able to print, the following maintenance steps will be required first: | ||
- | * Hot-head rebuild | ||
* Sourcing of power supply | * Sourcing of power supply | ||
* Manual levelling improvements (ideally) | * Manual levelling improvements (ideally) | ||
Line 113: | Line 97: | ||
It would be good for someone to itemise these at some point. | It would be good for someone to itemise these at some point. | ||
+ | {{tag> | ||
projects/other_3d_printers.1611310562.txt.gz · Last modified: 2021/01/22 10:16 by Ed