I have lost the second clip for my AquaPac waterproof phone case (see photo). I rate this product highly - I have used it for Windsurfing, Kayaking, camping etc. I lost the first clip a couple of years ago and the single clip was holding it's own until I lost that also. I now need to design clip replacements. After exhaustive searching, I have not found any pictures of the missing clips, so I have designed my own based off measurements take off the housing.

Job done

Well that was actually pretty easy. To the printer! The evening has defeated me, but I shall print the prototype tomorrow. Pending small updates (such as a small ledge off the shaft to keep the clip in-place when the case is open), I'll upload to thingiverse and myminifactory.


Early version source file (OpenSCAD)
Final version hosted on Thingiverse