projects:laser_cutter
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
projects:laser_cutter [2022/12/01 16:21] – andy | projects:laser_cutter [2022/12/03 18:02] – andy | ||
---|---|---|---|
Line 15: | Line 15: | ||
===== TODO ===== | ===== TODO ===== | ||
- | * Set laptop with print spool driver. | + | * Fix laser issue - [[https:// |
Line 21: | Line 21: | ||
===== Notes ===== | ===== Notes ===== | ||
* The hardware is a Trotec Speedy100 | * The hardware is a Trotec Speedy100 | ||
+ | * The maximum size of a sheet to cut is 610 x 305 mm | ||
+ | * Typically create designs in [[https:// | ||
+ | * In your design, use hairline red for cutting and black for engraving | ||
* The manual [[https:// | * The manual [[https:// | ||
+ | * Service manual {{ : | ||
+ | * The laser cutter is powered by a [[https:// | ||
+ | |||
The focus guide sits on the laser cutter like so... | The focus guide sits on the laser cutter like so... | ||
Line 34: | Line 40: | ||
* Some useful notes [[https:// | * Some useful notes [[https:// | ||
* Trotec samples and examples [[https:// | * Trotec samples and examples [[https:// | ||
+ | * | ||
projects/laser_cutter.txt · Last modified: 2022/12/03 18:03 by andy